ON / OFF
Switch Mode
Temperature
Intensity
+
Intensity
-
HOW TO USE - MANUAL MODE
POW ER ON/OFF
To switch on the appliance, long press (more than 2 seconds) the switch button. An
acoustic signal confirms the power on and the indicator light comes on. The product
turns on in the last state prior to shutdown.
To turn off the product, press and hold (more than 2 seconds) the switch button (the
indicator light turns off and the product emits a long beep).
TThe product will automatically shut down after 15 minutes of operation.
MODE SELECTION
To change mode, briefly press the switch button when the machine is on. You will hear
a beep and the massage mode changes according to the sequence: auto combination →
tap mode → scraping mode → acupuncture mode → manipulation mode → physiotherapy
mode
TEMPERATURE SELECTION
TTo change the temperature, press the temperature button : the temperature will
vary, with each press, following the sequence low → medium → high → off (no heating).
For each press, you will hear a beep (long beep at the maximum temperature)
INTENSITY SELECTION
To increase the intensity, press the Intensity + button: an acoustic signal will be heard
(a long beep signals the maximum intensity 18).
TTo decrease the intensity, press the Intensity - button: an acoustic signal will be heard
(a long beep signals the minimum intensity 0).
NOTE:
1. Using a wet towel to moisten the skin before use provides a better comfort.
2. The massager has a memory function, once you set your preferred mode, intensity and
temperature the first time, it will remain memorized.
3. Default working state: Beat mode, Intensity level 1, Temperature Medium
44. Since each person has different sensitivity for the massage, if during use you feel the
intensity is excessive, immediately lower the intensity to the minimum level.
5. If the massager it’s not in contact with the skin within a minute, it will automatically
turn off.
2
To Next Page
Loading...