CONNECTION
Before starting the connection, make sure that Bluetooth is activated on your
smartphone. To start the connection, start the "SMART MASSOR" App and select your
device from those detected via Bluetooth connection (the closer the device is to the
smartphone, the better the connection) as shown in Figure 1.
2 quick beeps signal that the connection is established
ByBy clicking on ①, as shown in Figure 2, you can: disconnect the device / start a Scan for
available Bluetooth devices / Reconnect the device.
MODE SELECTION
To change the massage mode, drag the slider ③ left / right (available modes: auto
combination → tap mode → scraping mode → acupuncture mode → manipulation mode
→ physiotherapy mode). Selecting a mode, you will hear 2 beeps in a row
INTENSITY SELECTION
TTo adjust the intensity of the massage, drag the slider ⑤ up / down. You will hear a
single beep (long beep at the minimum and maximum level). The system prevents too
large intensity variations in short times, in order to prevent possible inconveniences
during use.
TEMPERATURE SELECTION
To adjust the temperature, drag the slider ② left / right. You will hear a single beep
(long beep at the maximum level)
TIME SELTIME SELECTION
To adjust the massage time, drag the slider ④ up / down. You will hear a single beep.
To start the massage cycle, click ⑦
◦To start the Refresh mode, after setting the desired mode, intensity and
temperature, click ⑥. You will hear a beep and the icon turns on white. To turn off
the Refresh mode, click ⑥ again. You will hear a long beep and the icon turns off.
◦◦To activate the Key Lock (Elder Lock) Function, so as to prevent you from
accidentally pressing the keys, click on ⑧ (Elder Lock). With this function, only the
slider for adjusting the massage time and the ON / OFF button remain active. To
reactivate all other controls, remove the key lock by clicking on ⑧ (Elder Lock) again.
NOTE:
1.1. Since each person has different sensitivity for the massage, if during use you feel the
intensity is excessive, immediately lower the intensity to the minimum level, or press
the power button or the switching mode button on the App, to bring the intensity back
to the minimum level.
22. If the icon in the upper right corner of the App is gray, it means that the massager
is not in contact with the skin, and therefore will not work properly. When the massager
is properly in contact with the skin, the icon is white, and the massager will work
optimally
4
To Next Page
Loading...