Enso FE3500 Wireless Adjustable Base - Troubleshooting Lift and Massage; Lift Function Interference; Massage Motor Noise

In the event that the power foundaon fails to operate, assess the symptoms and possible soluons
provided in the chart below.
SYMPTOMS SOLUTIONS
Head & Foot li funcon has minor
interference during operaon.
Excessive massage motor noise.
Check baeries in wireless remote control, replace with two (2) new AAA baeries if
necessary.
Make sure that you are following the duty cycle of the motors (do not operate more than
two minutes over a 18-minute period, or approximately 10% duty cycle).
Press the li buons squarely and accurately.
Wireless remote control may be experiencing common Radio Frequency Interference
from other radio transming devices. Wait several seconds, and then try pressing
appropriate buon again, See FCC Compliance Statement on page 5 of this guide.
If the bed is located on hard surface flooring, place carpet pieces or rubber pieces (not
included) under each leg.
Using the wireless remote control, elevate the head, foot or neck secon a short distance
to realign the li/lower mechanisms with the bed support plaorm.
Verify that your Power Foundaon is not posioned against a wall, nightstand, or other
object that may cause the vibraon or noise.
If the Power Foundaon is installed over a bed frame, verify that the massage motors are
not causing the bed frame (or bed frame components) to vibrate.
Verify that the headboard aachment hardware is properly ghtened (if used).
22-23