Entrematic Ditec HA-8 - User Manual

Issued Sept 9, 2015
HA/FA-8 operator installation instructions
IMPORTANT INSTALLATION INSTRUCTIONS
WARNING – to reduce the risk of severe injury or death:
1. READ AND FOLLOW ALL INSTALLATION INSTRUCTIONS
2. Install only on a properly operating and balanced door. A door that is
operating improperly could cause severe injury. Have qualified service
personnel make repairs to cables, spring assemblies, and other
hardware before installing the operator.
3. Remove all pull ropes and remove, or make inoperative, all locks (unless
mechanically and/or electrically interlocked to the power unit) that are
connected to the door before installing the operator.
4. Install the door operator at least 8 feet or more above the floor if the
operator has exposed moving parts.
5. Do not connect the door operator to the source of power until instructed
to do so.
6. Locate the control station: (a) within sight of the door, (b) at a minimum
height of 5 feet so small children cannot reach it, and (c) away from all
moving parts of the door.
7. Install the Entrapment Warning Placard next to the control station in a
prominent location.
8. For products having a manual release, instruct the end user on the
operation of the manual release.

Summary

Installation Considerations

Header and Gearbox Installation

Header Box Mounting

Instructions for positioning and securing the header box to the doorframe, including wiring holes.

Push and Pull Header Types

Details on mounting header boxes for push and pull door installations, including dimensions.

Motor Drive and Electrical Connection

Steps for installing the motor drive unit and making electrical connections to the operator.

Arm Assembly Installation

Push Arm Installation Procedures

Step-by-step guide for installing the push arm assembly onto the door and header.

Pull Arm Installation Procedures

Tuning of Motor Gearbox

Door Stop Set and Windy Conditions

Back Check and Latching Adjustment

Modifying Spring Tension

Spring Tension Adjustment Procedure

Control Adjustments and ANSI Requirements

Electronic Controls Overview

ADA Adjustments

Opening and Closing Speed Settings

Latch Check and Controller Settings

Final Installation Procedures

Entrematic Ditec HA-8 Specifications

General

Brand	Entrematic
Model	Ditec HA-8
Category	Control Unit
Language	English