Enttec Pixelator 70060 - Page 7

User Manual
50657 (PIXELATOR)
www.enttec.com
US Patent Patenting ID: 2114 7
Connector pin out
Pixel Link pinout (RJ-45):
Pin1: Data +
Pin2: Data -
Pin7: Ground
RS232:
Pin 2: TX
Pin 3: RX
Pin 5: Ground
PLink System
• Each PLink port can drive up to 340 RGB
individual pixels (2 DMX universes) - PLink 2U
module must be used in Pixelator Profile
• PLink Injector sold separately (73546 / 73544)
• 1 PLink Injector needs to be used per PLink port
on the Pixelator
• External DC power supply
• Maximum distance between Plink Injector and
Tape/dots should not exceed 3m
• Data extensions can be up to 300m over Cat6
cable
• Supports pixel tape and dots based on 9PDOT-
8bit, 9PDOT-16bit, WS2811, WS2812, WS2812B and
APA-104 LEDs.
• Small, light and easy to hide design
• High power screw terminal connectors
• Easy wiring using straight Cat5/Cat6 standard
connections
Notes:
▪ Plink system only works with CAT5/6 straight-through cables, do not
use crossover cables.
Pixelator Specifications
Item
Value
Input Voltage
90-260V AC
Input Frequency
50/60Hz
Power Consumption
20W
Heat dissipation
65BTU/ Hour
Unit Weight
3kg/6.7lbs
Shipped Weight
3.6kg/8lbs
Length
With rack ears
483 mm/19.1 inches
Without rack ears
424 mm/16.7 inches
Width
With rack ears
240 mm/9.5 inches
Without rack ears
207 mm/8.2 inches
Height
32 mm/1.26 inches
Operating Environment
Temperature
0 - 50° Celsius
Certification
CE, FCC certified
Connectors
24 x Plink Output Ports
(RJ-45)
1 x Ethernet Connector
1 x RS232 Connector
2 x USB Host Connectors
(un-used)
Due to continuous improvements and innovation of all
ENTTEC products, specifications and features are subject to
change without notice.