4. Warranty Policy & Safety Info
Please register your product with the QR code
below to obtain full warranty benefits, or you
can only get a 2-year warranty.
Microinverter Safety
*DANGER: Risk of electric shock. Risk of fire. Do
not attempt to repair the Envertech Microinvert-
er; it contains no user-serviceable parts. If it fails,
contact Envertech customer service to obtain an
RMA (return merchandise authorization) number
and start the replacement process. Tampering
with or opening the Envertech Microinverter will
void the warranty.
*DANGER: Risk of fire. The DC conductors of the
PV module must be labeled “PV Wire” or “PV
Cable” when paired with the Envertech Microin-
verter.
*WARNING: You must match the DC operating
voltage range of the PV module with the allowa-
ble input voltage range of the Envertech Mi-
croinverter.
*WARNING: The maximum open circuit voltage
of the PV module must not exceed the specified
maximum input DC voltage of the Envertech
Microinverter. Using electrically incompatible PV
module voids Envertech’s warranty
*WARNING: Risk of equipment damage. Install
the microinverter under the PV module to avoid
direct exposure to rain, UV, and other harmful
weather events. Always install the microinverter
bracket side up. Do not mount the microinverter
upside down. Do not expose the AC or DC con-
nectors to rain or condensation before mating
the connectors.
*WARNING: Risk of equipment damage. The
Envertech Microinverter is not protected from
damage due to moisture trapped in the cabling
systems. Never mate microinverters to cables
that have been left disconnected and exposed to
wet conditions. This will void the Envertech war-
ranty.
*WARNING: Risk of equipment damage. The
Envertech Microinverter functions only with a
standard, compatible PV module with appropri-
ate fill-factor, voltage, and current ratings. Un-
supported devices include smart PV modules,
fuel cells, wind or water turbines, DC generators,
and non-Envertech batteries, etc. These devices
do not behave like standard PV modules, so op-
eration and compliance is not guaranteed. These
devices may also damage the Envertech Microin-
verter by exceeding its electrical rating, making
the system potentially unsafe.
*WARNING: Risk of skin burn. The chassis of the
Envertech Microinverter is the heat sink. Under
normal operating conditions, the temperature
could be 20°C above ambient, but under extreme
conditions, the microinverter can reach a tem-
perature of 90°C. To reduce the risk of burns, use
caution when working with microinverters.
*Note: Please do not violate the following con-
tent, otherwise the warranty will be invalid.
1. Ensure that the EVT2000 is properly grounded
during installation.
2. It is prohibited to connect more than one pho-
tovoltaic panel to a DC connector.
3. It is prohibited to use batteries and energy
storage products that have not been certified
by Envertech.
To Previous Page
Loading...
Need help?
General
