Chimney Installation
All congurations on this page are only to be used as a guideline. Please refer to pipe manufacturer’s installation
instructions and local building codes before installing any heating appliance.
Standard dimensions for exiting a roof.
Roof radiation shield
(required by some
manufacturers)
Roof radiation shield
(required by some
manufacturers)
Minimum air space
in accordance with
chimney listing
Wall radiation shield
(required by some
manufacturers)
Through the wall installation -
factory built chimney.
Standard ceiling installation -
factory built chimney.
1. GENERAL
a) The single wall stove pipe used to connect the stove to the ue, whether masonry or factory built, must be a
minimum of 24 gauge, blue or black steel. The pipe is to be a minimum 6" (15cm) inside diameter.
CAUTION: DO NOT USE GALVANIZED PIPE.
b) Secure the rst section of the pipe to the top of the cast adaptor. The pipe should be inserted into the cast piece
at least ” (2cm) for safety.
c) Secure every pipe joint with three or more sheet metal screws to prevent accidental separation.
d) If an elbow is installed, the horizontal section of the stove pipe should slope " per foot to run toward the stove
to allow creosote to drip into the rebox and burn.
IMPORTANT: DO NOT ATTACH
THIS UNIT TO A CHIMNEY
FLUE SERVING ANOTHER
APPLIANCE.
8
To Next Page
Loading...
Need help?
General