11
AFTER INSTALLATION THE END USER SHOULD
KEEP THIS GUIDE FOR FUTURE REFERENCE
DO NOT
THROW AWAY
10. With the mains supply isolated, wire the unit to the local isolator
as per the wiring diagram and in accordance with the local wiring
regulations. When the power is turned on, air will begin flowing into
the property after a few seconds.
10
11. If you are installing
a remote switch
(-RS) unit:
a) Open the switch
ensuring the ribbon
cable remains
connected to the PCB.
b) Screw the switch
to the wall in an
accessible location.
c) Replace the lid and
tighten the two screws.
MVHR UNIT
LOCAL ISOLATOR
To Next Page
Loading...
Need help?
General
