8
9. Connect the other end of signal cable to the VGA port of the PC system. Make sure the cable
head is securely connected.
10. Plug the female end of the power cord into the AC adaptor.
11. Connect the male end of the power cord into a wall socket.
12. Turn on your computer, and then turn on your LCD Monitor.
NOTE
For added protection, it is recommended to use a Surge Protection device plugged between
the AC Adapter and the electrical wall outlet to prevent the effects of sudden current
variations from reaching the LCD Monitor. Sudden peaks of electricity may cause damage to
the Monitor
OPERATING THE MONITOR
The LCD monitor has been preset at the factory with the Timing shown in Appendix to create optimal
picture. Users are also able to adjust the picture to the desired brightness and sharpness by following
the instructions.
Power
Plug into the AC
power adapter
Signal
Cable
Connect the Signal
Cable
Buttons Functions
1 EXIT / AUTO
CONFIG Button
Exit the OSD (On Screen Display) / Activate
Auto Configuration.
2 d
dd
dArrow key
Press to bring up the On Screen Display and
select main menu items
3 X
XX
XArrow key
Press to bring up the On Screen Display and
select sub menu items.
4 “-” Minus key
Adjust sub-setting bars i.e. CONTRAST,
BRIGHTNESS, etc. to decrease setting
values of the OSD.
5 “+” Plus key
Adjust setting bars i.e. CONTRAST,
BRIGHTNESS, etc. to increase setting
values of the OSD.
6 LED power
status display
Green – Normal operation
Red – Off Mode (reduced power
consumption < 5W when not receiving
horizontal and/or vertical sync signal)
7 Power Switch For turning ON/OFF the monitor
To Next Page
Loading...
