6
Appendix
6.1
Routine Maintenance
① When using the equipment, please handle it gently and avoid knocking
it;
②After the laser equipment has finished collecting, the laser protection
cover should be put on to prevent scratches on the laser lens;
③In daily use, pay attention to protecting it and avoid scratching its
appearance. If there is dust, use a dust-free cloth dipped in clean water to
gently wipe it;
④After using the device, it is necessary to remove the accessories and put
the mainframe and accessories into the packaging box.
6.2
Common Troubleshooting
After turning on the camera, it shuts down immediately, which may
be because the camera has not been charged for a long time and the
battery is low. Opening the device and charging the camera for about
10 minutes will allow it to start up normally.
If the camera does not take pictures during use, please manually turn
on the camera.
If the U disk is plugged and unplugged multiple times during the
collection process, it may cause the laser scanner's configuration
parameters to be reset to factory settings. If this happens, please
contact the after-sales personnel for remote setting of the scanner.
After successful setting, it will not affect the normal use of the device.
To Next Page