Epilog Laser Fusion Pro 48 Assembly Replacement

PRO 32 & 48 X-AXIS ASSEMBLY
22
2. Once in the Settings menu, press
the Focus button to enter the Focus
Commands/Calibrations menu:
3. Press the AF Plunger button:
4. Press the Start button.
5. Allow the engraver to complete the
calibration. Once complete, a success
message should appear.
If further assistance is required, reach out
to Epilog Laser Tech Support by phone at
303-215-9171, or by email at
tech@epiloglaser.com.

Epilog Laser Fusion Pro 48 Specifications

General

Brand	Epilog Laser
Model	Fusion Pro 48
Category	Engraver
Language	English