CONTINUED ON OTHER SIDE
CUTOUT TEMPLATE AND INSTALLATION GUIDE
ES
-
CORE
-
IC& IC
-
POINT
INTRODUCTION
Thank you for purchasing Episode® speakers. Visit our website for design recommendations and
speaker calculators.
NEW CONSTRUCTION INSTALL
Episode speaker installations can be simplified by using Episode pre-construction brackets (sold
separately). Install them prior to drywall to allow for precise placement of the speaker.
Secure the wiring within reach of the bracket for easy access.
EXISTING CONSTRUCTION INSTALL
Make a cutout for the speaker using the supplied template. Allow space for
the bezel if installing near adjacent objects, or cut the hole in two steps as
shown below.
1. Cut the drywall at a 45° angle so that if the speaker is too close to
an obstruction, you can easily ‘plug’ the hole. This is known as a
“pumpkin cut.”
2. If there are no obstructions, cut the drywall again, this time at a
90° angle.
3. Insert the speaker into the cutout.
OBSTRUCTION
PLUG
CONNECT
Strip the insulation on each conductor approximately ¼" and insert into the speaker
terminals. Ensure no strands of wire protrude from the connectors.
Observe proper polarity for each speaker to the amplifier (
+
to
+
and
–
to
–
).
Dual Voice Coil / Surround (DVCS) Selector Switch (Select Models)
There are two options for DVCS (Dual Voice Coil / Surround) models, selected by using the selector switch
on the crossover PCB. DVC (default position) and SURR.
Amp
SINGLE VOICE COIL
For DVC installs, wire the left channel to either
of the two connections and wire the right
channel to the other.
For SURR installs, wire the surround channel to
In1/SURR.
Do not use stereo inputs while in surround
mode.
To Next Page
Need help?
General
