EasyManua.ls Logo

Epomaker Brick 87 - Wireless Connectivity Guide; Bluetooth Pairing Procedure; 2.4 GHz Dongle Pairing; Sleep Mode Behavior

Epomaker Brick 87
7 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
PAIRING BLUETOOTH
Toggle the switch on the right side of the keyboard to make sure that the
keyboard is under the Bluetooth mode:
1.Hold Fn+1!/2@/3# for 3-5 seconds till the indicator flashes fast, the keyboard is
ready to pair.
2. Turn on your Bluetooth device and find the keyboard, then connect. When the
keyboard is connected to the Bluetooth device, the light on the 1!/2@/3# key stops
flashing and the connection is done.
3. Press Fn+1!/2@/3# to toggle between the Bluetooth devices 1/2/3.
PAIRING WIRELESS 2.4GHZ
Toggle the switch on the right side of the keyboard to make sure that the
keyboard is under the 2.4G mode:
1.Hold Fn+4$ for for 3-5 seconds till the light flashes fast in green, the keyboard is
ready to pair.
2. Insert the 2.4G dongle to your device, when the 4$ key stops flashing green, the
connection is done.
Note:The keyboard will enter sleep mode after 2 minutes of inactivity, the keyboard
lights go off, and it can be reactivated by any keypress.
WIRED MODE
Toggle the switch on the right side of the keyboard to switch to the wired mode. The
5% key stays white for 2s and goes off.
CHECK BATTERY
Hold Fn+B, the keys from 1!to O) lights up to show the battery percentage; for
example, if the keys from 1!to 6A light up when holding Fn+B, it means that the
battery life is currently 60%; if keys of 1!-0) light up, battery life is 100%.
Note: When the keyboard is at low battery, the right indicator flashed red; when the
keyboard is charging, the light stays green for 5s and goes off.

Related product manuals