Epsolar MT50 - 5.8 Device Parameters

5.9 Device Password
The password of the solar charge controller could be modied via the page
of device password; the device password is a 6-digit gure which is required
before entering the modication mode of “Control parameter”, “Load setting”,
“Device parameter”, “Device password”, “Factory reset” pages. The page of
device password in the diagram below:
Device PSW
OriPSW：XXXXXX
NewPSW：XXXXXX
Note: Solar charge controller default password is”000000”
5.10 Charge mode
The charge mode of solar charge controller could be selected via the page
of charge mode (Voltage Compensate, SOC); the default charge mode is
Voltage Compensate charge mode.
Charge Mode
Vol.Compen./SOC
24
书籍1.indb 24 2013-10-18 15:04:23