Using the Auto Take-Up Reel
Using the Auto Take-Up Reel
You can wind paper forward or backward.
Before you print, make sure you press and select .
Winding Paper Forward
1
Set the paper guides to the forward position.
6 Hold down the Auto Forward button on the
control panel to rotate the take-up reel and wind a
small length of paper.
7 When you’re ready to print, make sure Auto Cut is
set to Off in the printer driver.
Winding Paper Backward
1
Set the paper guides to the vertical position.
2 Align the edge of the paper with the horizontal
and vertical lines. Then press the button to feed
the paper.
2 Align the edge of the paper with the horizontal line.
Then press the button to feed the paper.
3 Use three pieces of tape to attach the paper to the
take-up reel core.
4 Press the button to feed the paper and create
some slack.
5 Press the button until appears on the LCD.
3 Pull the paper around the back of the take-up reel
core and use three pieces of tape to attach the paper
to the core.
4 Press the button to feed the paper and create
some slack.
5 Hold down the Auto Backward button on the
control panel to rotate the take-up reel and wind a
small length of paper.
6 When you’re ready to print, make sure Auto Cut is
set to Off in the printer driver. Then send your print
job to the printer.
3
To Next Page
Loading...
