Replacing Printer Parts (continued)
Replacing Printer Parts (continued)
6 Hold down the side pin, as shown, then turn the
latch to the right.
7 Release the side pin and carefully remove the cutter
blade.
Replacing the Maintenance Tank
You need to replace one of the maintenance tanks
(part # C12C890191) when you see
MAINT TANK
FULL on the LCD, along with an indication of which
tank is full.
1 Check the LCD to determine which tank needs to
be replaced.
8 Insert the new cutter blade.
9 Hold down the side pin while turning the latch to
the left.
10 Close the front cover. The cutter returns to the home
position.
8
2 Make sure the printer is on, and pull out the
maintenance tank as shown.
Caution: Do not tip the tank, or ink may spill out.
3 Place the used tank in the plastic bag included with
the new tank.
4 Insert the new tank.
Center
tank
Left
tank
Right
tank
To Next Page
Loading...
