17
Loading the Roll Paper
Follow the directions below to mount the Roll paper holder and
load the roll paper.
1. Set roll paper in the roll paper holder.
Note:
Remove the transparent sheet after setting the roll paper into the
holders.
2. Check that the end of the roll is cut perpendicularly to the
edges as shown. For A4 and 329-mm width paper, cut along
one of the parallel lines on the back. For 89- and 100-mm width
paper, use a triangle.
c
Caution:
Always use a triangle or other tool to ensure that the end of
the roll is cut perpendicularly. A diagonal cut may cause
paper feed problems.
To Next Page
Loading...
