21
Note:
EPSON recommends that you use a triangle or other tool to ensure
that the end of the roll is cut perpendicularly. A diagonal cut may
cause paper feed problems.
3. Once you have cut the paper, hold down the
z roll paper
button for about 3 seconds. The paper feeds in reverse to a
position where it can be easily removed from the sheet feeder
at the back of the printer. If it does not feed to this position,
repeat this step.
4. Gently remove the paper. Then, press the
z roll paper button
to clear the error light.
Your document has now been printed.
To Next Page
Loading...
