Specifying the Destination Address (Scan to E-mail/FTP/SMB)
Scan data can be sent via the network to a specified address (e-mail address, FTP address or SMB
address). The address can be typed in directly, or an address registered on the machine can be selected.
Note:
❏ To send scan data via the network, settings for NETWORK SETTING and E-MAIL SETTING (when
sending to an e-mail address) must be specified.
❏ If the size of the scan data sent by e-mail exceeds the size specified with FILE SIZE, the data is
automatically divided into multiple e-mail messages. For details, refer to “SCAN SETTING Menu”
on page 66.
❏ To save scan data in a shared folder on a computer installed with Windows or on the FTP server, the
FTP address or SMB address must be registered as a speed dial destination. These addresses can be
registered only from Local Setup Program or Web-Based EpsonNet Config. For details, refer to the
Reference Guide.
Directly Entering the E-mail Address
The destination address (e-mail address) where the scan data is to be sent can be directly typed in.
Note:
A maximum of 16 addresses (total of e-mail addresses from direct input and an LDAP search) can be
specified.
1. In the main screen (Scan mode), use the keypad to type in the destination address.
Note:
For details on entering/editing text, refer to Facsimile User’s Guide.
2. After the text is entered, press the Select key.
3. If an e-mail address was selected, press the u or d key to select FINISH, and then press the Select
key.
Note:
To add an additional e-mail address, select ADD in step 3, and then specify the destination.
To edit the specified e-mail address, select CHECK/EDIT in step 3, and then continue with step 2 of
"Editing a Specified Destination Address". To delete an address, select CHECK/EDIT in step 3, and
then continue with step 2 of "Deleting a Specified Destination Address".
Epson AcuLaser CX37 Series Printer/Copier/Scanner User’s Guide
Using the Scanner 147
To Next Page
Loading...
