Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD
Revision G
Artisan 837/730/PX830FWD/PX730WD/TX730WD
Disassembly/assembly 303
Confidential
2. Lift the rib section of the Front Panel Unit Cover slightly and slide it in the
direction of the arrow to release the hooks (x8) of the Front Panel Unit Cover,
and then remove the Front Panel Unit Cover.
Figure 9-26. Removing the Panel Unit (2)
3. Disconnect the Panel FFC from the connector on the Panel Unit.
(See Fig. 9-27.)
4. Remove the Panel Unit from the Upper Housing.
Figure 9-27. Removing the Panel Unit (3)
Front Panel Unit Cover
Hook of Front Panel Unit Cover
Rib section
Panel Unit
Panel FFC
Connector
Upper Housing
When installing the Panel Unit, align the positioning hole on the
left side of the Panel Unit with the dowel of the Upper Housing.
(See
Fig. 9-25.)
Before installing the Panel Unit, insert the Panel FFC Cover
into the hole of the Upper Housing.
Figure 9-28. Installing the Panel Unit
A D J U S T M E N T
R E Q U I R E D
After removing/replacing the Panel Unit, make the specified
adjustments. (See
"9.5 Adjustment" (p.321).)
Panel FFC Cover
Hole of Upper Housing
Upper Housing
Panel Unit
To Next Page
Loading...
