85
6. Do one of the following to load folded or irregularly shaped originals using a carrier sheet:
Note: Use only the carrier sheet designed for your product. The carrier sheet is automatically
recognized by the product by the two small rectangular holes on the front edge. Keep the holes
clean and not covered. Do not load a carrier sheet that has scratches on it or one that has been
scanned more than 3,000 times.
• For a larger original, fold it as shown and place it in the center of an optional carrier sheet. Make
sure the illustration on the front edge of the carrier sheet is facing up. To scan both sides and
stitch them together, set the appropriate setting in Epson Scan 2.
• For an irregularly shaped original, load it in the center of an optional carrier sheet with the printed
side face down. Make sure the illustration on the front edge of the carrier sheet is facing up. If you
are loading originals that are 11.7 inches (297 mm) or shorter, place the leading edge of the
To Next Page
Loading...
Need help?
General
