• If your network assigns addresses automatically, set the DHCP
setting to On.
• If you must set addresses manually, set the DHCP setting to Off
and enter the projector's IP Address, Subnet Mask, and Gateway
Address as necessary.
a
To highlight the numbers you want from the displayed
keyboard, press the arrow buttons on the remote control. To
select a highlighted number, press [Enter].
i
To prevent the IP address from being displayed on the standby
screen, set the IP Address Display setting to Off.
j
When you finish selecting settings, select Complete and follow the
on-screen instructions to save your settings and exit the menus.
Related Links
• "Wired Network Projection" p.99
Wired Network Projection
101
To Next Page
