Epson EB-450W Installation Guide

16
(2) Insert the slide plate into the setting plate from the interface side of the projector (A).
Align the marks on the projector and the setting plate (
B).
(3) Tighten the two M5 x 12 mm hexagon socket head cap bolts (
C).
E Connect the power cable and other cables to the projector
Connect any necessary cables such as the power cable, computer cable, and USB cable to the projector.
Projector
interface side
M5 x 12 mm hexagon
socket head cap bolts (2)
Marks
Bolt positions
Slide plate
If you use adhesives to prevent the screws from loosening or things such as lubricants or oils
on the slide plate fixing part of the projector, the case may crack and cause the projector to fall,
resulting in personal injury or property damage. Do not use adhesives, lubricants, or oils to
install or adjust the setting plate.
Warning
Power cable
Computer cable
USB cable

Epson EB-450W Specifications

General

Projection technology	LCD
Contrast ratio (typical)	2000:1
Projector native resolution	WXGA (1280x800)
Aspect ratio	16:10
RS-232 ports	1
Dimensions (WxDxH)	369 x 481 x 115 mm
Lamp type	UHE
Lamp power	230 W
Light source type	Lamp
Service life of light source	2500 h
Service life of light source (economic mode)	3500 h
Focal length range	0 - 4.68 mm
RMS rated power	10 W
Serial interface type	RS-232
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Component video (YPbPr/YCbCr) in	2
Power consumption (standby)	1 W
Operating temperature (T-T)	0 - 35 °C

Weight and Dimensions

Weight	5700 g