Epson EB-450W User Manual

• When Sync. is changed from the Signal menu in the Configuration
Menu.
• When Position is changed from the Signal menu in the Configuration
Menu.
• When Aspect is changed from the Signal menu in the Configuration
Menu.
• When input detection is performed automatically.
• When position offset becomes a problem for other reasons.
q
• If you set Projection to Rear/Ceiling from the Extended menu in the
Configuration menu, Easy Interactive Function cannot be used
because the pen position and mouse position will not match.
• The pen position and mouse position will not match while E-Zoom
is being used.
• When you use Easy Interactive Function while images are projected
with EasyMP Network Projection (input source: LAN), set USB
Type B to Wireless Mouse or Off from the Extended menu in the
Configuration Menu.
Tablet Function
If Easy Interactive Driver is installed, the tablet function for Windows Vista
or Windows 7 is enabled. When Office 2003/2007/2010 is installed on the
computer you are using, the Ink function in Office allows you to use Easy
Interactive Pen as a mouse.
System Requirements
OS
The following 32 bit operating systems:
Windows Vista
*
Windows Vista Service Pack 1 or later
*
Windows 7
The following 64 bit operating systems:
Windows 7
*
Except for the Starter Edition
Checking availability
When Easy Interactive Driver is installed, check that the tablet function is
enabled.
For Windows 7
Click Control Panel - System and Security and then System.
If Pen and Single Touch Input Available is displayed in Pen and Touch,
the tablet function is available.
For Windows Vista
Click Control Panel and then System.
If Available is displayed in Tablet PC functionality, the tablet function is
available.
Replacing the Batteries for the Easy Interactive
Pen
When the button is pressed, the indicator for the Easy Interactive Pen turns
on. If it does not turn on, the batteries are out of power and need to be
replaced. Have two AAA size alkaline batteries ready. For details on other
Easy Interactive Function (EB-465i/455Wi only)
62

Epson EB-450W Specifications

General

Projection technology	LCD
Contrast ratio (typical)	2000:1
Projector native resolution	WXGA (1280x800)
Aspect ratio	16:10
RS-232 ports	1
Dimensions (WxDxH)	369 x 481 x 115 mm
Lamp type	UHE
Lamp power	230 W
Light source type	Lamp
Service life of light source	2500 h
Service life of light source (economic mode)	3500 h
Focal length range	0 - 4.68 mm
RMS rated power	10 W
Serial interface type	RS-232
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Component video (YPbPr/YCbCr) in	2
Power consumption (standby)	1 W
Operating temperature (T-T)	0 - 35 °C

Weight and Dimensions

Weight	5700 g