EasyManua.ls Logo

Epson EB-485Wi - The Remote Control Does Not Work; I Want to Change the Language for Messages and Menus

Epson EB-485Wi
165 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Check Remedy
Are you using a plug-in power type microphone? The projector does not support plug-in power type microphones. Use a commercially available dynamic microphone.
s Settings - Mic Input Level p.101
The remote control does not work
Check Remedy
Is the remote control light-emitting area pointing towards the
remote receiver on the projector during operation?
Point the remote control towards the remote receiver during operation.
s "Remote control operating range" p.19
Is the remote control too far from the projector? The operating range for the remote control is about 6 m.
s "Remote control operating range" p.19
Is direct sunlight or strong light from fluorescent lamps shining onto
the remote receiver?
Set the projector up in a location where strong light does not shine onto the remote receiver. Or set the remote receiver to
Off from Remote Receiver in the Configuration menu.
s Settings - Remote Receiver p.101
Is the correct setting for the Remote Receiver selected? Check the Remote Receiver from the Configuration menu.
s Settings - Remote Receiver p.101
Are the batteries dead or have the batteries been inserted in the
wrong direction?
Insert new batteries in the correct direction.
s "Replacing the remote control batteries" p.18
I want to change the language for messages and menus
Check Remedy
Change the language setting. Adjust the Language setting from the Configuration menu.
s Extended - Language p.103
Problem Solving
133

Table of Contents

Other manuals for Epson EB-485Wi

Related product manuals