EasyManuals Logo

Epson EB-530 User Manual

Epson EB-530
193 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #144 background imageLoading...
Page #144 background image
Indicators Status Explanation
Power supply Status
Blue - Lit Blue - Flashing
Warm-up status This is the status immediately after turning on the projector. Warm-up takes approximately 30 seconds after
the lamp turns on. In this status you cannot turn off the projector, even if you press the [t] power button.
Cool down status This is the status immediately after turning off the projector. In this status, all buttons are disabled.
Blue - Lit
Blue - Lit
Normal status The projector is projecting.
Refer to the following table to see what the indicators mean and how to remedy problems that they indicate.
If all indicators are off, check that the power cord is connected correctly and that the power is being supplied normally.
Sometimes, when the power cord is unplugged, the [
t
] power indicator remains lit for a short period, but this is not a fault.
Indicators Cause Remedy or Status
Power sup-
ply
Status Lamp Tempera-
ture
Off Blue - Flash‐
ing
Orange -
Flashing
Off
Internal Error Stop using the projector, remove the power plug from the electrical outlet, and contact your local
dealer or the nearest address provided in the Epson Projector Contact List.
s Epson Projector Contact List
Off Blue - Flash‐
ing
Off Orange -
Flashing
Fan Error
Sensor Error
Stop using the projector, remove the power plug from the electrical outlet, and contact your local
dealer or the nearest address provided in the Epson Projector Contact List.
s Epson Projector Contact List
Off Blue - Flash‐
ing
Off Orange - Lit
High Temp Error
Overheating
The lamp turns off automatically and projection stops. Wait for about five minutes. After about five
minutes the projector switches to standby mode, so check the following two points.
Check that the air filter and air exhaust vent are clear, and that the projector is not positioned
against a wall.
If the air filter is clogged, clean or replace it.
s "Cleaning the Air Filter" p.163, "Replacing the Air Filter" p.169
If the error continues after checking the points above, stop using the projector, remove the power
plug from the electrical outlet, and contact your local dealer or the nearest address provided in the
Epson Projector Contact List.
s Epson Projector Contact List
Problem Solving
144

Table of Contents

Other manuals for Epson EB-530

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Epson EB-530 and is the answer not in the manual?

Epson EB-530 Specifications

General IconGeneral
Number of colors1.07 billion colors
Native aspect ratio4:3
Projection distance0.5 - 1.3 m
Vertical scan range50 - 85 Hz
Projection technology3LCD
Supported aspect ratios-
Contrast ratio (typical)16000:1
Screen size compatibility50 - 108 \
Projector native resolutionXGA (1024x768)
Keystone correction, horizontal-15 - 15 °
Projector brightness (economic mode)1800 ANSI lumens
FocusManual
Throw ratio0.55:1
Focal length range6.4 mm
Lamp power215 W
Light source typeLamp
Service life of light source5000 h
Service life of light source (economic mode)10000 h
Full HDNo
Video processing10 bit
Microphone inYes
USB connector typeUSB Type-A, USB Type-B
Serial interface typeRS-232
USB 2.0 ports quantity2
VGA (D-Sub) ports quantity3
Ethernet LAN data rates10, 100 Mbit/s
Noise level37 dB
Country of originChina
Noise level (economic mode)29 dB
RMS rated power16 W
PlacementDesktop
Product typeShort throw projector
Product colorWhite, Grey
Market positioningPresentation
Cable lock slot typeKensington
AC input voltage100-240 V
AC input frequency50 - 60 Hz
Power consumption (standby)0.28 W
Power consumption (typical)298 W
Power consumption (PowerSave)221 W
Storage temperature (T-T)-10 - 60 °C
Operating temperature (T-T)5 - 35 °C
Storage relative humidity (H-H)10 - 90 %
Operating relative humidity (H-H)20 - 80 %
Cables includedAC, VGA
Bundled softwareEasyMP Monitor, iProjection, EasyMP Network Projection
Pallet width800 mm
Pallet height2250 mm
Pallet length1200 mm
Pallet weight0 g
Pallet width (UK)1000 mm
Quantity per pack1 pc(s)
Quantity per pallet40 pc(s)
Quantity per pallet (UK)60 pc(s)
Quantity per pallet layer4 pc(s)
Harmonized System (HS) code85286200
Quantity per pallet layer (UK)6 pc(s)
USB display function3 in 1: Image / Mouse / Sound
Sustainability certificatesTCO
Weight and Dimensions IconWeight and Dimensions
Depth315 mm
Width344 mm
Height94 mm
Weight3700 g
Package depth490 mm
Package width385 mm
Package height210 mm
Package weight5860 g

Related product manuals