Check Remedy
Is the computer set for dual display?
(Only when projecting computer images)
If dual display is activated in the Display Properties of the computer's Control Panel, only about half of the image on the
computer screen is projected. To display the entire image on the computer screen, turn off the dual display setting.
s Computer video driver documentation
Is the correct resolution selected?
(Only when projecting computer images)
Set the computer so that the signals being output are compatible with the projector.
s "Supported Monitor Displays" p.127
s
Computer's documentation
Image colors are not right
Check Remedy
Do the input signal settings match the signals from the connected
device?
Change the following settings according to the signal for the connected equipment.
• When the image is from a device connected to the Computer1 or Computer2 port.
s Signal - Input Signal p.78
• When the image is from a device connected to the Video or S-Video port.
s Signal - Video Signal p.78
Is the image brightness adjusted correctly? Adjust the Brightness setting from the Configuration menu.
s Image - Brightness p.77
Are the cables connected correctly? Check that all the cables required for projection are securely connected.
s "Connecting Equipment" p.22
Is the
contrast
g
adjusted correctly? Adjust the Contrast setting from the Configuration menu.
s Image - Contrast p.77
Is the color adjustment set correctly? Adjust the Color Adjustment setting from the Configuration menu.
s Image - Color Adjustment p.77
Are the color saturation and tint adjusted correctly?
(Only when projecting images from a video source)
Adjust the Color Saturation and Tint settings from the Configuration menu.
s Image - Color Saturation, Tint p.77
Problem Solving
103
To Next Page
Loading...
Need help?
General
Weight and Dimensions
