c
While holding down the [Menu] button, connect the power cord
to the projector.
When the projector's indicators turn on as follows, release
the [Menu] button.
Power: Blue - On/Status: Blue - On/Lamp: Orange - On/Temp: Orange - On
The indicators remain on for about 75 seconds.
When all of the indicators start flashing, the settings are being
written.
Caution
• Do not disconnect the power cord from the projector while the
settings are being written. If the power cord is disconnected, the
projector may not start correctly.
• Do not disconnect the USB storage device from the projector while the
settings are being written. If the USB storage device is disconnected,
the projector may not start correctly.
d
When writing completes normally, the projector enters standby
status.
Power: Blue - On
When the projector is in standby status, remove the USB storage
device.
Setup by Connecting the Computer and Projector
with a USB Cable
a
The following operating systems support the batch setup function.
• Windows Vista or later
• Mac OS X 10.5.3 or later
Performing Batch Setup for Multiple Projectors
123
To Next Page
Loading...
