No sound can be heard from the microphone (EB-955WH/EB-950WH/EB-965H/EB-945H/EB-940H/EB-98H/EB-97H only)
Check Remedy
Is the microphone connected correctly? Disconnect the cable from the Microphone (Mic) input port, and then reconnect the cable.
s "Connecting External Equipment" p.33
Is the microphone input volume turned down too low? Adjust the microphone input volume so that sound can be heard.
s Settings - Mic Input Level p.105
Is Plug-in Power set correctly? When using a condenser microphone, set Plug-in Power to On from the menu.
s Extended - A/V Settings - Plug-in Power p.106
The remote control does not work
Check Remedy
Is the remote control light-emitting area pointing towards the
remote receiver on the projector during operation?
Point the remote control towards the remote receiver.
s "Remote control operating range" p.22
Is the remote control too far from the projector? The operating range for the remote control is about six meters.
s "Remote control operating range" p.22
Is direct sunlight or strong light from fluorescent lamps shining onto
the remote receiver?
Set the projector up in a location where strong light does not shine onto the remote receiver.
s Settings - Remote Receiver p.105
Is the correct setting for the Remote Receiver selected? Check the Remote Receiver from the Configuration menu.
s Settings - Remote Receiver p.105
Are the batteries dead or have the batteries been inserted correctly? Make sure the batteries are inserted correctly or replace the batteries with new ones if necessary.
s "Replacing the remote control batteries" p.21
I want to change the language for messages and menus
Check Remedy
Change the Language setting. Adjust the Language setting from the Configuration menu.
s Extended - Language p.106
Problem Solving
143
To Next Page
Loading...
