199
Setting Options Description
Standby Mode Standby Mode
Port
Enable this setting to allow the
following operations to occur
when the projector is in standby
mode:
• Monitor and control the
projector over a network
• When monitoring or controlling
the projector using wireless
LAN, set Connection mode to
Advanced
Port: selects the port to use from
Wired LAN or Wireless LAN
when Standby Mode is set to
Communication On
HDBaseT Control Communications
Extron XTP
Selects the communication
settings for connections to an
HDBaseT transmitter or switcher
Control Communications:
enables or disables
communication from the Ethernet
and serial ports on the
transmitter; turning on this setting
disables the projector's LAN, RS-
232C, and Remote ports (Extron
XTP must be turned off to use
this setting)
Extron XTP: set to On when you
connect an Extron XTP
transmitter or switcher to the
HDBaseT port
To Next Page
Loading...
