Adjusting the Image
43
Loading a Memory
a
Press the button, and then select Load Memory.
The Load Memory screen is displayed.
b
Select the target memory name.
c
•
The color mode saved to the memory is displayed on the right.
•
Depending on the input signal, part of the loaded memory item may not be applied to the
projected image.
•
Memories saved for 2D images can only be loaded when projecting 2D images. Memories saved
for 3D images can only be loaded when projecting 3D images.
Deleting a Saved Memory
a
Press the button, and then select Erase Memory.
The Erase Memory screen is displayed.
b
Select the target memory name.
A confirmation message is displayed. If you select Yes, the content of the saved memory is erased.
c
If you want to erase all of the saved memories, go to Reset - Reset Memory on the
Configuration menu.
s
p.75
Renaming a Memory
You can rename each memory name using up to 12 characters. Giving the memory a name that is easy to
remember is useful when loading the memory.
a
Press the button, and then select Rename Memory.
The Rename Memory screen is displayed.
b
Select the target memory name.
The name list screen is displayed.
c
Select a displayed name or Customized.
To enter a name of your own, select Customized, and then go to step 4. If you select Customized, a
keyboard is displayed.
If you select from the name list, check that the memory name has been changed.
To Next Page
Loading...
Need help?
General
