7
EnglishFrançaisDeutschItalianoEspañol
中文
(
简体
)
中文
(
繁体
)
日本語
D
Make sure the lens unit is not at an angle,
and insert it straight into the lens insertion
section.
E
While holding the lens unit firmly, hold the
lock lever and turn it clockwise to lock the
lens unit.
Check that the lens cannot be detached.
If it cannot be locked, the lens unit is at an
angle. Remove and then reinstall the lens unit.
F
Tighten the M3 screws (4 points) with a
commercially available No. 2 cross-head
screwdriver.
To Next Page
Loading...
