Why does my Epson Projector power not turn on?
If your Epson Projector isn't powering on, ensure the power cable is correctly connected to the projector. Also, verify that the outlet is receiving power, by checking the circuit breaker. If the problem persists, try reinserting the power cable. If it still doesn't work, there may be a poor contact in the power cable, or the power cable may be defective.
How to fix an Epson EMP-62 remote control that is not working?
If the Epson Projector remote control isn't working, make sure you're within 6 meters of the projector and facing the remote control light-receiving area, with an operating angle of approximately ±30º horizontally and approximately ±15º vertically. Check for direct sunlight or strong fluorescent light interfering with the remote control light-receiving area. Also, ensure the batteries are correctly inserted or try new batteries. Releasing the button resumes normal operation if any button on the remote control is pressed down for more than 30 seconds, which would cause the remote control to stop sending signals.
What does it mean when the power light is orange on my Epson Projector?
The orange power light on your Epson Projector indicates that the lamp needs replacing. Replace the lamp with a new one as soon as possible, because using the lamp beyond its replacement period increases the risk of it breaking. The Power indicator status will vary depending on the projector status at the time.
What to do if my Epson Projector shows a red light and overheats?
If your Epson Projector is showing a red light, it could be due to a high temperature error (overheating). In this case, the lamp will turn off automatically and projection will stop. Wait about 5 minutes, after that the projector will switch to standby mode. Check that the air filter and air exhaust vent are clear, and that the projector is not positioned against a wall. If the air filters are blocked, clean or replace them.
Why is the power light on my Epson EMP-62 Projector red and orange?
The Epson Projector's red and orange power light indicates a high temperature warning. Check that the air filters and air exhaust vent are clear and that they are not up against a surface such as a wall. If the air filters are clogged, clean or replace them.
What does it mean when the power light is red on my Epson EMP-62 Projector due to a lamp problem?
If your Epson Projector displays a red light, there may be a lamp issue. Check that the lamp is not cracked and that the air filter and air intake vent are clear. Remove the lamp and check if it is cracked. Clean the air filter and the air intake vent. If the lamp is not cracked, replace the lamp and turn on the power. If the error still occurs, replace it with a new lamp and turn on the power.
General| Resolution | 1024 x 768 (XGA) |
|---|---|
| Contrast Ratio | 500:1 |
| Display Technology | 3LCD |
| Zoom Ratio | 1.2x |
| Projection Size | 30 - 300 inches |
| Weight | 2.7 kg |
| Brightness | 2200 ANSI Lumens |
| Lamp Type | UHE |
| Input Connectors | VGA, S-Video, Composite Video, Audio (RCA) |
| Output Connectors | VGA |
| Lamp Life | 2000 hours (Normal mode), 3000 hours (Eco mode) |
To Next Page
