Epson ET2710 Series - Page 37

3. Load paper at the center of the paper support with the printable side facing up.
c
Important:
❏ Do not load more than the maximum number of sheets
specied
for the paper. For plain paper, do not load
above the line just under the
d symbol inside the edge guide.
❏ Load paper short edge rst. However, when you have set the long edge as the width of the user dened size,
load paper long edge rst.
❏ Pre-punched paper
Note:
❏ Load a single sheet of dened size plain paper with binding holes at the le or right.
❏ Adjust the print position of your le to avoid printing over the holes.
4. Slide the edge guides to the edges of the paper, and then close the feeder guard.
c
Important:
Do not place objects on the feeder guard. Doing so may prevent paper from feeding.
User's Guide
Preparing the Printer
37