Plugging in the Scanner
1.
Connect the power cable to the power inlet on the back of
the scanner and plug the other end into a properly
grounded outlet as shown below.
e
Caution:
There are several versions
of
this scanner designed for
dzjJimxt
voltages, and it is not possible to change the
scanner’s voltage.
If
the label on the back of the scanner
does
not show the correct voltage for your country, contact
your dealer.
2.
If any of the scanner’s lights come on, press the
OPERATE
button to turn off the scanner.
e
Caution:
Whenever
~024
turn off the scanner, wait at least 10 seconds
before turning it back on. Rapidly turning the scanner on
and off may damage it.
1-4
Setting Up the Scanner
To Next Page
Loading...
