Epson L605 - Disassembly;Reassembly Procedures

To Next Page

To Previous Page

ConfidentialConfidential

Dis

Disaasssseemmbbllyy//ReReaasssseemmbbllyy CoCommmmoon cn caauuttioionns s wwhheen dn disisaasssseemmbbllining/g/rereaasssseemmbbllining tg thhe e ProProdduucctt 3366

InInk k SySyststemem 1.1. TaTake ke cacare re nonot tt to o ststaiain yn youour hr hanands ds wiwith th inink.k.

2.2. When yoWhen you conneu connect the ink ct the ink tube to atube to another pnother part, insert thart, insert the ink tue ink tube up tobe up to

the root of the joint to prevent ink leakage and secure the tube with thethe root of the joint to prevent ink leakage and secure the tube with the

tube clamp.tube clamp.

3.3. If it's hard If it's hard to inserto insert the ink t the ink tube to tube to the jointthe joint, apply , apply CR06 to CR06 to the inserthe insertingting

part of the inpart of the ink tube.k tube.

------

Ink SupplyInk Supply

TankTank

When handling the Ink Supply Tank, do not put it with the ventilation holeWhen handling the Ink Supply Tank, do not put it with the ventilation hole

(A in the figure on the right) downward. (See(A in the figure on the right) downward. (See

"2.1.5 Checks and Precautions

before Disassembling (p28)before Disassembling (p28) ""

))

MACMAC

AddressAddress

LabelLabel

1.1. Take Take care care not tnot to sto stain ain or dor damagamage it.e it.

2.2. When reWhen replacing placing the Housthe Housing Upping Upper, transfeer, transfer the MAr the MAC addresC address label tos label to

the new Housing Upper.the new Housing Upper.

Ink Supply TankInk Supply Tank

Housing UpperHousing Upper

2.2.



E ppssoon n EE TT--44555500, , LL665555//665566 RReevviissiioon n BB

2.3 2.3 Disassembly/Reassembly Disassembly/Reassembly ProceduresProcedures

2.3.1 2.3.1 Functional differences Functional differences between models between models and component and component partsparts

InIn "2.3.2 Disassembly Flowchart (p38)""2.3.2 Disassembly Flowchart (p38)", the procedures are indicated on the premise that some parts/units are, the procedures are indicated on the premise that some parts/units are

removed in advance. Make sure to remove the removed in advance. Make sure to remove the following parts/units before starting disassembly.following parts/units before starting disassembly.



Cassette AssyCassette Assy