2 Mobilink TM-P60 Installation Manual
Figure 2-1. COM1 Port Example
2.4 Load Media
The following instructions explain how to install the roll paper in the Mobilink TM-P60.
1. Open the roll paper cover by pressing the button beside it.
2. Remove the used roll paper core (if applicable) and insert the new roll. Paper feeds from the bottom out
between the tear bar and the cover.
3. Extend a short section of paper, close the cover and tear off the extra paper using the tear bar.
2.5 Set Printer Defaults
Follow these instructions to default the printer:
1. Open door
2. Hold down the FEED button and press the
POWER button
3. Press the FEED button six times
4. Close door
5. Open door
6. Press FEED one time
7. Close door
NOTE: Some important default settings to remember:
• Default IP: 192.168.192.168
• Default subnet mask: 255.255.255.0
• Default SSID: EpsonNetIBSS (case
sensitive)
• Default port: 9100
• Default channel: 11
To Next Page
Loading...
