Epson Mobilink TM-P80II - Charging the Battery; Charging the Battery Using the Included USB Cable

37
Chapter 2 Setup
Charging the Battery
Charging the Battery using the Included USB Cable
1
Connect the included USB-C cable to the printer.
2
Connect the USB-C cable to a commercially available USB power adapter or
computer.
3
The charge LED lights up when charging starts.
If the battery level is close to full, charging will not start.
Check the battery level with the battery LED.
U"Battery LED" on page 22
4
The charge LED turns off when charging is complete.
5
Disconnect the USB-C cable from the printer.
• When charging the battery, install the battery to the printer.
• Charge the battery in an environment of approximately 0 to 40 °C (32 to 104 °F).
• When the printer is used for the first time, the battery needs to be charged for approximately 2.5
hours.
• Use a USB Type-C power adapter or USB port that complies with the USB Type-C Standard.
• Only USB Type-C standard power mode is supported. The charging time varies depending on
the power supply capability and settings of the USB power adapter and port.
U"Electrical Characteristics" on page 100