3 Once you’ve confirmed the settings, click
the Options button. The SilverFast Defaults
screen appears:
4 For Gamma-Gradation, enter 2.20. Check
for HDR output, then click the CMS tab.
The CMS Defaults screen appears:
5 Turn off all the color management options
for the target scan. You need to do this
whenever you scan a profiling target.
In the Color Management section, set
Scanner->Internal and Internal->Monitor
to <NONE>, and set Internal->Output to
RGB.
In the Profiles for ColorSync section, set
all profiles to <NONE>. You can leave
the other settings at their defaults.
6 When you’ve completed all the settings,
click OK.
7 On the main SilverFast screen, click the
Frame tab. Set the Scan Type to 48-bit
HDR Color, and set the resolution slider to
300 dpi, as shown:
15
To Next Page
Loading...
