Building the Scanner Transparency
Profile in MonacoEZcolor
Once you’ve scanned the target, you have
everything you need to build the scanner profile in
MonacoEZcolor, as described in this section.
1 Launch MonacoEZcolor. The Welcome
screen appears:
2 Click Create Input Profile, then click the
right arrow to proceed. The intermediate
screen contains hints about scanning the
target, which you’ve already done, so you
can skip it. The following screen appears:
3 Choose 4x5 Transparency. Then click the
right arrow twice to proceed to Input the
Target, as shown. (The intermediate screen
covers steps that you’ve already performed,
so you can skip them.)
4 Click Load Image, and load the target scan
you created in the previous section. The
target’s file name is displayed below the
Load Image button, as shown:
17
To Next Page
Loading...
