Epson Perfection V600 - Page 11

My scanned image does not show the texture of my original document. What should I
do?
Select the Show Texture check box on the Other menu in the Configuration dialog box.
Note:
o Show Texture increases scanning time.
o If you select the Show Texture check box after previewing, do preview again to confirm
the effect of the Show Texture function.
o Show Texture is not available in Full Auto mode.
o Show Texture is not available when scanning films.
o DIGITAL ICE Technology is not available when the Show Texture check box is selected
and reflective document is selected as Document Type.
o The Show Texture check box is cleared when you restart the Epson Scan.
Ripple patterns appear in my scanned image when using Epson Scan. What should I do?
A ripple or cross-hatch pattern (called moiré) may appear in a scanned image of a printed
document. It is caused by interference from the differing pitches in the scanner's screen
and the halftone screen in your original. Try the following if this occurs:
Original image
Descreening applied
o Select the Descreening check box in Office Mode, Home Mode, or Professional Mode. In
Professional Mode, select an appropriate Screen Ruling for the Descreening and
deselect the Unsharp Mask setting. See Adjusting the Color and Other Image Settings
for instructions.
o Select a lower Resolution setting. See Selecting the Scan Resolution for instructions.
Note: You cannot remove ripple patterns when you are scanning film or monochrome
images, or scanning using a resolution higher than 600 dpi.