Cleaning the Scanner Glass
To keep your scanner operating at its best, you should clean it periodically (every three months).
Follow these steps to clean your printer:
c
Caution:
O Be careful not to injure your hand on parts inside the printer.
O Do not press the glass surface of the scanner with any force.
O Be careful not to scratch or damage the glass surface of the scanner, and do not use a hard or
abrasive brush to clean it. A damaged glass surface can decrease the scan quality.
O Do not touch the clear sheet inside the printer.
O Never use alcohol, thinner, or corrosive solvent to clean the scanner. These chemicals can
damage the scanner components.
O Be careful not to spill liquid into the scanner mechanism or electronic components. This could
permanently damage the mechanism and circuitry.
O Do not spray lubricants inside the scanner.
1. Turn off the printer and remove any paper loaded in the printer.
2. Use a soft dry lint-free cloth to carefully wipe away all dirt from the surface of the glass.
Copyright © 2010 Seiko Epson Corporation. All rights reserved. BPS0091-00 EN
To Previous Page
Loading...
