164
Power light Status light Lamp light Temp light Status and solution
Off Flashing blue Orange Off Lamp or lamp cover has a problem
• Check to see if the lamp is
burned out, broken, or installed
incorrectly; reseat or replace the
lamp as necessary
• Clean or replace the air filter
• If operating the projector at high
altitude, turn on High Altitude
Mode
• If the problem persists, unplug
the projector and contact Epson
for help
• Check that the lamp cover is
installed correctly
Flashing blue Light status
varies
Flashing
orange
Light status
varies
Replace the lamp soon to avoid
damage; do not continue using the
projector
Off Flashing blue Off Flashing
orange
A fan or sensor has a problem; turn
the projector off, unplug it, and
contact Epson for help
Off Flashing blue Flashing
orange
Off Internal projector error; turn the
projector off, unplug it, and contact
Epson for help
Off Flashing blue Flashing
orange
Flashing
orange
Auto iris error; turn the projector off,
unplug it, and contact Epson for
help
Off Flashing blue Orange Orange Power error; turn the projector off,
unplug it, and contact Epson for
help
Note: If the lights display a pattern not listed in the table above, turn the projector off, unplug it, and
contact Epson for help.
Parent topic: Solving Problems
To Next Page
Loading...
Need help?
General