Epson PowerLite 1720 Installation Handbook

INSTALLATION
HANDBOOK
Remote Control Information
Epson PowerLite 1720 / 1730W
10
Operating Two or More Projectors with
the Remote Control
If you’re using more than one projector, you can control all the
projectors—or just selected ones—by using the projector and remote
control ID system. First assign a unique ID number to each projector.
Then set the remote control to match the ID of the projector you
want to operate. This lets you control it without aecting the others.
Setting the Projector ID
The projector’s default ID is set to O. This lets it respond to
commands from any remote control. To change the ID, follow these
steps:
1. Press the
Menu button on the remote control. You see the
projector’s menu screen.
2. Select
Extended > Projector ID.
3. Use the pointer button to highlight the new ID, and press
Enter to select it.
4. When done, press
Menu to exit the menu system.
Checking the Projector ID
To check the ID of a specic projector:
1. Point the remote control at the projector you want to check.

Epson PowerLite 1720 Specifications

General

Brand	Epson
Model	PowerLite 1720
Category	Projector
Language	English