Input Signal Settings - Signal Menu
Normally the projector detects and optimizes the input signal settings automatically. If you need to
customize the settings, you can use the Signal menu. The available settings depend on the currently
selected input source.
Note: You can restore the default settings of the Position, Tracking, and Sync settings by pressing the
Auto button on the remote control.
To change settings for an input source, make sure the source is connected and select that source.
Setting Options Description
Auto Setup On Automatically optimizes computer
image quality (when On)
Off
Resolution Auto Sets the input signal resolution if
not detected automatically using
Wide
the Auto option
Normal
Tracking Varying levels available Adjusts signal to eliminate vertical
stripes in computer images
111
To Next Page
Loading...
Need help?
General