Lamp Replacement Update
Please substitute the lamp replacement instructions below for the instructions in your Epson
®
PowerLite
®
61p/81p User’s Guide:
1. Press the P
Power button twice to turn off the projector. When the projector beeps twice,
unplug the power cord.
2. If the projector has been on, allow it to cool down for at least an hour (or until the lamp is cool).
Warning: Let the lamp cool before replacing it. If the lamp breaks, handle the shards carefully to
avoid injury.
3. Use a screwdriver to loosen the screw holding the lamp cover. (The cover is on top of the
projector.)
4. Slide the cover out, then lift it off.
5.
6. Use the screwdriver to loosen the two screws holding the lamp in place. You can’t remove them.
7.
Turkey lamp replacement slipsheet.fm Page 1 Wednesday, June 30, 2004 12:16 PM
To Next Page
Need help?
General