5 • Maintenance
136
4. Use a screwdriver, coin, or similar object to loosen the two
screws holding the lamp assembly in position. (You can’t
remove these screws either.)
Caution:
Don’t touch the glass portion of the lamp assembly;
this can cause premature lamp failure.
5. Lift up the handle and pull out the lamp assembly.
6. Gently lower the new lamp into position and make sure it’s
inserted securely. Tighten the screws on the new lamp
assembly.
7. Replace the lamp cover and tighten the cover screw. (Make sure
the lamp cover is securely fastened. The projector won’t run if
the lamp cover is open.)
2
1
To Next Page
Loading...
