Epson PowerLite 7550C - Unpacking the ELP Link III Kit

4 • Using ELP Link III
86
Note:
If your computer doesn’t have a PS/2 mouse connector, you
must use the ELP Link III kit to connect the projector to a computer.
If you purchased the optional ELP Link III kit, you need to connect
the special ELP Link III cables after you’ve finished connecting the
projector’s power cable, video cable, and audio cable (if needed), as
described in Chapter 1.
This chapter covers:
p
Unpacking the ELP Link III kit
p
Connecting the ELP Link III cables
p
Installing the software
p
Using the software
Unpacking the ELP Link III Kit
When you unpack the ELP Link III kit, make sure you have all these
components:
Main cable
9-pin serial cable (PC set)