1 • Setting Up the Projector
44
The projector supports NTSC, PAL, PAL60, and SECAM video
formats, and automatically detects and identifies the video format.
However, if automatic selection is not possible for some reason, you
can specify that a specific video format be detected (see page 74).
Note:
If you change the Video Signal setting in the Setting menu to
specify a particular video format, the projector will be able to detect
only the format specified. To have the projector automatically detect
any supported video format, reset the Video Signal setting to Auto.
Follow these steps to connect a video device:
1. Turn off the projector and video device, if they’re on.
2. Locate the appropriate video cable:
p
If your video source has a large, round, four-prong S-Video
connector, use the cable that came with your video device, or
purchase an S-Video cable from your computer dealer.
p
If your video source has a small, round, one-prong composite
(RCA) video connector, use the audio/video (A/V) cable that
came with the projector. (The A/V cable has three RCA
plugs on either end of the cable.)
To Next Page
Loading...
