Epson PowerLite 78 - Connecting to Video Equipment

Setting Up the Projector 27
Connecting to Video Equipment
You can connect several video sources to the projector at the same
time. Before starting, look at your video equipment to determine its
available video output connections:
■ PowerLite W6 Series only: If your video player has an HDMI
connector, see “Connecting an HDMI Video Source
(PowerLite W6 Series only)” on page 28.
■ If your video player has a yellow RCA video output connector, see
“Connecting a Composite Video Source” on page 29.
■ If your video player has an S-Video connector, see “Connecting
an S-Video Source” on page 30.
■ If your video player has a component video port (three connectors
labeled either Y/Cb/Cr or Y/Pb/Pr), see “Connecting a
Component Video Source” on page 31.
■ If your video player has an RGB video port, see “Connecting an
RGB Video Source” on page 32.
After connecting video cables, you may also want to connect an
optional audio cable to play sound through the projector; see page 34.
If you connect using an HDMI cable (PowerLite W6 Series only), the
video and sound are both transferred and you won’t need to connect
any additional cables for audio.